Search results

Hey everyone, I recently purchased a Mossberg 500 ATI Scorpion. The instructions for the ATI accesories say there should be silicone pads on the V-block spacers that rest up against the barrel under the short sections of picatinny rails. There are no silicone pads on the V-block spacers on my...

Hey everyone, I recently purchased a Mossberg 500 ATI Scorpion. The instructions for the ATI accesories say there should be silicone pads on the V-block spacers that rest up against the barrel under the short sections of picatinny rails. There are no silicone pads on the V-block spacers on my...

I think I will try the flight control. If I stick with the S&B I will definitely have to get some good lead remover! Thanks again!

Definitely not sticking to the magnet, the only other thing it could be is lead. I think I will stop using these cheap Sellier & Bellot 00 Buckshot and get some Federal with the flight control wad, should be much easier to clean after shooting. Thanks for your help, really appreciate it!

Great Idea! I just checked the metal shavings on my cleaning mat with a strong magnet and they do not stick. I assume this means it is not the lining of my barrel?

Thanks for the reply. I am hoping it is just leading. The shells I am using are clear and I can see the 9 pellets sitting at the top of the shell, they are not in a plastic wad.

Hi All, I have a new Mossberg 590 Shockwave. I was at the range today shooting it and when I got home and started cleaning it, There were lots and lots of metal shavings coming out of the barrel. The gun was clean before I started shooting it. I was afraid the lining of the barrel was coming...

Thank you for the welcome and for your reply!

Hi, I am new to the forum and could use some help. I just purchased a Mossberg shockwave and I notice that the bolt lock is a bit chewed up with chips of metal missing. I am hoping someone with more experience than me with shotguns can tell me if this is a problem or not. Thanks in advance for...