1. Check out the Hot Deals section of the Marketplace forum to order an official Mossbergowners.com hat.

Machined Trigger Guard MVP 223/556

Discussion in 'Crosshair Precision' started by Robert Lynch, Dec 3, 2014.

  1. Robert Lynch

    Robert Lynch Sponsor Sponsor

    Hi MVP shooters, this is a machined trigger guard assembly for the MVP line up in 223/556. It will fit the Flex model as well, but was never really intended for it. This part is also made form 6061 t6 and uses the same black anodized finish with a mil spec hard coating. I have noticed that its much easier to get a good lock down on the rear action screw because there is no give in the metal. Its a beefy good looking part that serves its purpose. As always our parts are US made. If you have any interest in this part just send me a pm. These are 40 dollars shipped to your door in the US. I can ship outside as well and can provide quotes.

    001.JPG 014.JPG
    Last edited: Dec 3, 2014
    DHonovich likes this.
  2. DHonovich

    DHonovich Founder Staff Member Administrator Sponsor "Philanthropist"

    Looks solid!
    Robert Lynch likes this.
  3. yogi

    yogi Copper BB

    thinking about purchasing a MVP varmint. checked one out at LGS, seemed a pretty tight
    instrument but did notice plastic trigger guard and seemed that rear action bolt tightening
    down on it even with aluminum pillar behind would break eventually. you still offering
    a metal preplacementg at that price?
  4. DOW130

    DOW130 Copper BB

    I'd like to buy one of these from you. How can I get it done!
  5. Water Monkey

    Water Monkey The man, the myth, the monkey Moderator Supporter

    I have one. It's top quality.
  6. zzrguy

    zzrguy .410

    Are these still available. Anyone have a contact number for this guy. I read some where he ran into production issue

Share This Page