I got bored last night so I decided to do a little work on my G19. I've been wanting to stipple the frame for quite a while but never got around to doing it (when I pulled out the wood burner I bought specifically to do this the receipt was dated Aug of 2010 ). Last night I took the plunge. After a bit of trial and error on a pmag to get the pattern I wanted I jumped right into the Glock frame
I went a little too aggressive on the underside of the beavertail but I can fix that with a bit of fine grit sandpaper. Aside from that, I'm happy with the way it turned out it does not slip in the hand at all. I did notice that the fleece pullover I wore today stuck to it a lot more.
This is my EDC and the gun I use when I shoot in a local IDPA practice league.
I went a little too aggressive on the underside of the beavertail but I can fix that with a bit of fine grit sandpaper. Aside from that, I'm happy with the way it turned out it does not slip in the hand at all. I did notice that the fleece pullover I wore today stuck to it a lot more.
This is my EDC and the gun I use when I shoot in a local IDPA practice league.