Kungfunerd
.410
I picked up some Uncle Mikes screw in swivel studs today.
Any advice before I start drilling?
Any advice before I start drilling?
Or, rather than the nut/bolt combo you can back fill the segmented portion of the stock with some epoxy to further support the front mount. There is plenty of material in the rear but, as peteinpa points out the front stock attachment will be through much thinner synthetic material.peteinpa said:I found that the front stud location plastic is very thin. Use a "nut and bolt" type of stud.
BTW this rifle is MORE then worthy of a bipod and scope for accuracy.