I went to the range today, It's been about a week since I changed out the extractor in the rifle and put a new scope on it.
I had a hand load test that I was looking to test today and boy did I. The first 4 groups were all a little low by an inch, then I threw some factory ammo in and got the scope dialed in and went back to testing. I used Hornady cases, Benchmark powder, and all bullets were 55gr Hornady bullets, Varmint soft point, vmax, FMJBT, and a few other groups that I didn't take photos of (40g nosler Varmingeddon)
The first few groups were close but didn't feel right, nor did it feel consistent.
CCI 400 Primers
Group 1
group 2
Group 3
Group 4
Group 5
Group 6 I did two different groups on this because I jerked the trigger on one of them
Group 7
Group 8
hornady .223 55g vmax cannular
Group 9
Group 10
I had a hand load test that I was looking to test today and boy did I. The first 4 groups were all a little low by an inch, then I threw some factory ammo in and got the scope dialed in and went back to testing. I used Hornady cases, Benchmark powder, and all bullets were 55gr Hornady bullets, Varmint soft point, vmax, FMJBT, and a few other groups that I didn't take photos of (40g nosler Varmingeddon)
The first few groups were close but didn't feel right, nor did it feel consistent.
CCI 400 Primers
Group 1
group 2
Group 3
Group 4
Group 5
Group 6 I did two different groups on this because I jerked the trigger on one of them
Group 7
Group 8
hornady .223 55g vmax cannular
Group 9
Group 10