Thought I'd bump this instead of starting a new thread.
Installed a Midwest Industries long rail (pn: MCTAR-03) on the forearm of my 930, so I could properly mount the switch for my light.
The install went pretty smooth, but took some work to get it fit. I had to grind down the screws and nuts. The nuts have a large flange with a raised section, so there is more thread engagement. I had to drill a large hole (Z drill bit), so the raised section is a press fit into the handguard. I had to grind down the nuts to an overall height of approx. 0.150", so the flange would pull tight to the inside of the handguard. The screws are ground down, so they don't protrude threw the back of the nuts.
I didn't get any inprogress photos, but here are a couple of the final product.
Installed a Midwest Industries long rail (pn: MCTAR-03) on the forearm of my 930, so I could properly mount the switch for my light.
The install went pretty smooth, but took some work to get it fit. I had to grind down the screws and nuts. The nuts have a large flange with a raised section, so there is more thread engagement. I had to drill a large hole (Z drill bit), so the raised section is a press fit into the handguard. I had to grind down the nuts to an overall height of approx. 0.150", so the flange would pull tight to the inside of the handguard. The screws are ground down, so they don't protrude threw the back of the nuts.
I didn't get any inprogress photos, but here are a couple of the final product.