Re: Lenth of pull
One could do much the same thing with the poly stock. Just replacing the recoil pad with a thin buttstock plate, as I suggested earlier, would net about 3/4". If you're only looking for an inch, the thin plate would be the fastest/easiest way to get darn close. Not as cool a project, I'll admit, but it would get the job almost done.
Smitty in CT said:BenSamp said:The easiest way to mosify the ength of pull on a 930 would be to get a wooden stock and cut it back to fit, with a thin butt plate instead of a recoil pad, you could get 1-1/2" - 2" without modifying the recoil tube...
Smitty
One could do much the same thing with the poly stock. Just replacing the recoil pad with a thin buttstock plate, as I suggested earlier, would net about 3/4". If you're only looking for an inch, the thin plate would be the fastest/easiest way to get darn close. Not as cool a project, I'll admit, but it would get the job almost done.